Configure the network (Set the HSM IP address)

for this step, you must log in with an identity that has a role with permissions communication\ network settings you can use the default administrator role and admin identities choose one of the following methods to configure the network go to the configuration menu and modify the ip address configuration as required run the network interface modify fxcli command to set an ip address for the hsm the following example shows the command syntax fxcli network interface modify interface ethernet1 –ip 10 221 0 10 –netmask 255 255 255 0 – gateway 10 221 0 1 at this point during the hsm configuration, consider the following you can complete the remaining hsm configurations in this section by using the {{guard}} (see the applicable guide for configuring hsms for pkcs #11 integrations using the {{guard}} ), except for the final section, which covers creating connection certificates for mutual authentication if you are performing the configuration on the hsm directly but plan to add it to a guardian later, you might have to synchronize the hsm after you add it to a device group on the guardian if your use case requires configuration through a cli, then you should manage the hsms directly