Data storage
Pure Storage FlashArray
Enable Rapid Data Locking (RDL)
6min
WARNING
After you enable RDL, disabling it obliterates all data stored in the array.
This section shows how to enable and test Rapid Data Locking (RDL).
Run the following purearray enable security-token command to enable RDL use of the KMIP server:
Run the following command to list the new security-token:
You can use the purearray test security-token command to test the security-token with RDL enabled.
Allow up to 30 minutes for the purearray test command to accurately reflect the configuration.
The Status column reports the following success or failure options:
Status
Description
OK
A TLS connection could be established with the KMIP server and a basic KMIP Locate request is successful.
Fail
Failure can be due to two main categories of error:
- Cannot connect and authenticate with the server: For example, the KMIP server URI is not reachable, or the certificate is not in the correct format, not a complete certificate, or not a certificate file.
- Server is not ready for KMIP operations: For example, the certificate cannot be authenticated by the KMIP server, or the KMIP server cannot successfully respond to the Locate request.
Updated 01 May 2024
Did this page help you?